Combining barometric pressure and temperature sensing, the InvenSense ICP-10125 provides IPX8 waterproofing to more than 100 meters (10 ATM). The MEMS barometric pressure sensor offers four different measurement modes for optimizing power, noise, accuracy, and measurement frequency. It can measure pressure differences accurate to within ±1 Pa—an accuracy that enables altitude measurement differentials as small as 8.5 cm.
The device’s capacitive MEMS architecture enables it to achieve low noise and low power consumption. It also ensures temperature stability, providing a temperature coefficient offset of ±0.5 Pa/°C from 25°C to 45°C at 100 kPa. In ultra-low noise (ULN) mode, the ICP-10125 provides a pressure noise rating of 0.4 Pa with current consumption of 10.4 μA. In low power mode (LP), the sensor’s noise rating is 3.2 Pa at 1.3 μA. The part’s extended pressure range is 30 to 110 kPa. Maximum operating temperature range is -40°C to +85°C.
The ICP-10125 is well-suited for smart watches, wearable fitness monitors, and battery-powered IoT devices, as well as indoor/outdoor navigation (dead-reckoning, floor/elevator/step detection). It comes in a small 3.55×3.55×1.45-mm chimney package with waterproofing gel. The uniform machined lid and grooved chimney enable easier handling during production and product assembly.
Taped and reeled, the ICP-10125 barometric pressure sensor costs $2.98 each in lots of 3000 units. A development board is also available and includes the necessary software to jumpstart development and evaluation of the ICP-10125.
Find more datasheets on products like this one at Datasheets.com, searchable by category, part #, description, manufacturer, and more.