Study raises questions about validity of standard model of solar flares


Study raises questions about validity of standard model of solar flares
Temporal evolution of the spine-fan flare observed at 171 Å by the SDO/AIA on 2014 September 24. (a) The initial phase of the spine-fan flare (Fig. 1) recorded at 17:48:11 ut. (b) The main flare (red, larger box) and the remote brightening source (blue, smaller box). (c) Running-difference image to highlight the presence of an eruptive plasma. Credit: Monthly Notices of the Royal Astronomical Society (2024). DOI: 10.1093/mnras/stae1511

Solar flares are extremely intense events that occur in the sun’s atmosphere, lasting anywhere from a few minutes to several hours. According to the standard flare model, the energy that triggers these explosions is transported by accelerated electrons that hurtle from the magnetic reconnection region in the corona to the chromosphere.

As the electrons collide with the chromospheric plasma, they deposit their energy in the plasma, which is heated and ionized as a result. They also cause intense radiation in several bands of the electromagnetic spectrum. The regions in which energy is deposited are termed solar flare “footpoints,” which normally appear in magnetically connected pairs.

A recent study set out to test the validity of the standard model by comparing results of computer simulations based on the model with provided by the McMath-Pierce telescope during the solar flare SOL2014-09-24T17:50. The study focused on measuring time lags between infrared emissions from two paired chromospheric sources in the flare and is published in the journal Monthly Notices of the Royal Astronomical Society.

“We found a significant difference between the observational data from the telescope and the behavior predicted by the model. In the observational data, the paired footpoints appeared as two very bright regions of the ,” said Paulo José de Aguiar Simões, first author of the article and a professor affiliated with the Radio Astronomy and Astrophysics Center (CRAAM) at Mackenzie Presbyterian University’s Engineering School (EE-UPM) in São Paulo, Brazil.

“Because the incident electrons exited the same region of the corona and followed similar trajectories, the two spots should have brightened almost simultaneously in the chromosphere according to the model, but the observational data showed a delay of 0.75 seconds between them.”

A lag of 0.75 sec may seem irrelevant, but the researchers calculated that the maximum delay according to the model should be 0.42 sec considering all possible geometric configurations. The actual number was almost 80% higher.

“We used a sophisticated statistical technique to infer the time lags between footpoint pairs, and estimated uncertainties for these values by the Monte Carlo method. Furthermore, the results were tested by electron transport simulations and radiative-hydrodynamic simulations,” Simões said.

“By deploying all these resources, we were able to construct different scenarios for the electrons’ time of flight between the corona and the chromosphere and the infrared radiation production time. All scenarios based on the simulations displayed far smaller time lags than the observational data.”

One of the scenarios tested was for spiraling and magnetic trapping of electrons in the corona.

“Using electron transport simulations, we explored scenarios that involved magnetic asymmetry between flare footpoints. We expected the electron chromosphere penetration time lag to be proportional to the difference in magnetic field intensity between footpoints, which would also increase the difference in the number of electrons reaching the chromosphere owing to the magnetic trapping effect.

“However, our analysis of X-ray observational data showed footpoint intensities to be very similar, pointing to similar amounts of electrons deposited in these regions and ruling this out as the cause of the observed emission time lags,” he said.

The radiative-hydrodynamic simulations also showed that ionization and recombination timescales in the chromosphere were too short to explain the lags.

“We simulated the infrared emission timescale. We calculated electron transport to the chromosphere, electron energy deposition, and its effects on the plasma: heating; expansion; ionization and recombination of hydrogen and helium atoms; and radiation produced at the site, which has the effect of releasing excess energy,” Simões said.

“Infrared radiation is produced as a result of the increase in in the chromosphere due to ionization of hydrogen, which is originally in a neutral state in the plasma. The simulations showed that ionization and occur almost instantly owing to penetration by the accelerated , and therefore can’t explain the lag of 0.75 sec between footpoint emissions.”

In sum, none of the processes simulated in accordance with the model proved capable of explaining the observational data. The conclusion drawn by the researchers was obvious to some extent: the standard model of needs to be reformulated, as required by the scientific method.

“The lag observed between chromospheric sources challenges the standard model of energy transport by electron beam. The longer delay suggests other energy transport mechanisms may be involved. Mechanisms such as magnetosonic waves or conductive transport, among others, may be necessary to account for the observed delay. These additional mechanisms should be taken into consideration to achieve a full understanding of solar flares,” Simões said.

More information:
Paulo J A Simões et al, Precise timing of solar flare footpoint sources from mid-infrared observations, Monthly Notices of the Royal Astronomical Society (2024). DOI: 10.1093/mnras/stae1511

Citation:
Study raises questions about validity of standard model of solar flares (2024, September 23)
retrieved 23 September 2024
from https://phys.org/news/2024-09-validity-standard-solar-flares.html

This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no
part may be reproduced without the written permission. The content is provided for information purposes only.





Source link